I mentioned ETA because is the largest of the Swiss companies there are also Rhonda FE, ISA. Sometimes the movements are discontinued due to the age, but you still can get parts, so you can clean the old ETA movement and order a coil, a circuit or both to make that special watch work again. The calendar wheel can be replaced, so if you do not find the same movement with the calendar at 6 o’clock, you’ll have to remove the old calendar wheel and replace it in the new movement. Also be aware of how thick the dial is, because sometimes the same movement has a long and short center shaft (canon pinion). If it has a calendar window, is it located a 3 o’clock 4 o’clock 6 o’clock. When you are ready to work in a watch, you should consider if the watch has a seconds hand, if the watch has a calendar window. Some watchmakers would use their own nomination and should be crossed reference with standard ETA. If you need parts or a new movement, sometimes the identification is located by the battery, sometimes in one corner by the coil, sometimes it is in the circuit board. That number would be your reference number. It is the glassy red dot where the pivot of the wheel sometimes goes through. 955-114, 2001-001 also will tell you how many jewels if there are any. Japanese watch movements are sometimes are more costly than Swiss watch movements, but it is lesser quality and it’s difficult to work on a movement made of plastic.Ī Swiss movement will have stamp of 3 letters – E.T.A. Swiss watch movements are better quality and normally have a higher labor rate for repair.
Sometimes it is hard to tell them apart, especially in the low grade, and in the very high end. Open a watch and look inside, you are looking at either a Japanese watch movement or a Swiss watch movement.
0 kommentar(er)
